density

(redirected from optical density)
Also found in: Dictionary, Thesaurus, Medical, Legal, Acronyms, Encyclopedia, Wikipedia.

density

In zoning, the number of things allowed per unit of land, such as number of houses, occupants,or families per acre.

References in periodicals archive ?
Therefore, a plot of measured optical density, as a function of a single bacterial optical density calculated from the structural parameters in Table 1, is shown in Figure 3, where the measured optical density is fitted using the linear equation:
The rate strongly correlated with the optical density and the growth phase of the cultures.
The average optical density (IOD/area) of MMP-9 in the cornea was significantly higher compared with the control group at 7, 15, 30, and 60 days after operation (i = -21.21, -43.85, -14.71, -22.97, P < 0.05; Table 1).
The optical density readings from the spectrophotometer were linear between optical densities of 1.0 to 3.0, but below 0.8 sensitivity of the smartphone app was limited.
Both MMP-2 and MMP-9 epidermal expression, assessed by mean optical density, were not significantly different between lesions and uninvolved skin in 3 anetoderma patients.
The inhibition rate of NO production was calculated as inhibition rate (%) = [1 - (sample optical density - blank optical density)/(control optical density - blank optical density)] x 100.
Optical density of all target microorganisms at different concentration of essential oil Essential oil Target microorganisms concentration B.
aureus with maximum value of optical density for chromium at a molarity of 1.43 x [10.sup.-5] with optical density of 1.122.
To provide this the solution is poured into the same cuvette for which a curve is constructed and the same filter is turn on, and its optical density is determined.
The light guide material will be used Poly (methyl methacrylate (PMMA)) due to its low optical density, good impact strength and its transmissivity (transmits up to 92% of visible light in the wavelength range of 400nm and 1100nm (for 3 mm thickness sheet)).
The optical density (OD) values recorded for control and fiber reinforced specimen's shows an increase in the optical density of the order of <Cu fiber <hair fiber.
The graph below the blot depicts mean optical density and SEM (n = 3) of each band relative to the optical density of the corresponding band for a- tubulin and normalized to OE Ctrl = 1.00.

Full browser ?