Complete Fill

Complete Fill

A communication from a broker to a client stating that the broker was able to buy or sell all the shares the client requested. See also: Fill or kill.
References in periodicals archive ?
At 12% cerium, mold-filling capability declined and the metal temperature was adjusted upwards to 1,427F (775C) to achieve complete fill.
These include refinements to the Z-Molding Flow Front Control (FFC), which balances multicavity and family molds by halting injection just before complete fill and allowing the compressed melt to relax and expand uniformly into all cavities.
Enduron powders are bulky, making it easier to achieve complete fill (speaking in terms of the case capacity with a bullet seated) or a slightly compressed load.
The vehicle will have the option to alternate between the CNG and petrol driving modes, which ultimately increases its overall run on a complete fill.
Because the darn limits the flow, this two-step process allows for a lower viscosity material to fill the darn--leading to a faster, more complete fill under and around the connecting wires and a more uniform encapsulation height compared to glob-top dispensing.
Rockwool are one of the world's leading suppliers of insulation materials and their product which is used by the Warm Zone teams has several important qualities as it: Ensures a complete fill without settlement Will not allow water to migrate across cavity Vapour permeable - allows construction to breathe, reducing condensation risk British Board of Agrment certification for use up to 25m height Cost effective solution for new build and refurbishment Take advantage of current prices HOUSEHOLDERS in Northumberland are being urged to take advantage of current rates for loft and cavity wall insulation.
Difficulties in ensuring a complete fill of the annulus.
Should UMRC produce continued solid operational performance, maintain ILU occupancy at CRC of approximately 90%, and complete fill up on the new campus in Dexter, an upgrade would be likely.
4) Check small standoffs or blind pockets for complete fill.
The three-piece design of the mold was adopted to achieve (1) complete fill of the mold cavity during the embossing process, (2) a mold with sharp edges and tight dimensional tolerances, (3) easy cleaning of residual polymers after embossing, and (4) evacuation of trapped air during the embossing process.
The liner, System Elite Combo Cube, has been designed and constructed to fit the footprint of the Combo box IBC perfectly, allowing complete fill and discharge with the minimum of operator intervention.
Performance-wise, it meets the Daimler requirement of a three-to-four minute complete fill with a delivered gas temperature of -40oC, the best available today.
Full browser ?