The coefficients of variation were lower than for the above-discussed tension test
results because OSB properties tend to be homogeneous at large scale.
say it was very thin), no relative sliding between the TPU coatings and the fabric was observed during the peel and uniaxial tension tests
The engineering stress-strain curves obtained from tension tests
are shown in Fig.
The fact of necking that would occur in a tension test
can be ignored.
Also, it uses the fracture toughness of the 0[degrees] ply, which is measured in compact tension test
The tension tests
were performed using the 25 kN testing stand .
For the tension test
we used a hydraulic tensile test-machine with an acquisition data plate.
In tension test
fracture through base metal (not weld) was obtained in the cases, when standard flux, glass powder, and powder mixture of 70% glass and 30% cast iron was used in the welding process.
Mechanical properties of the material of specimens defined by results of tension test
agrees GOST 1497-84 "Metals.
methods for wood, wood-base materials and sandwich construction.
The nominal stress-strain relationship for cyclic planar tension test
is given by:
was performed with specimens from these samplers.