Limited evidence exists for kinematic analysis of the movement on the thrust fault plane: north-south oriented
chatter marks in the New Glen Brook area and slickenlines and crystal fibre lineations oriented 090-100[degrees] in the Goose Cove Brook area (Fig.
* Splice marks are similar to chatter marks but are caused by a poor belt splice.
* Slow it down--Running your conveyor belt slower will allow more time for abrasive sanding to remove the chatter marks.
In order to meet the quality requirements of the Japanese transplant car producers, Sunprene has developed PVC grades that they say eliminate surface imperfections from the extrusion process, such as gels, pinholes, ripples, waves and "
chatter marks." Other key physical properties featured in the three product lines reportedly include enhanced abrasion, cold-impact and chemical resistance, heat aging, and flexing fatigue, compared with EPDM rubber and existing PVC grades.
For large areas or deep imperfections like
chatter marks (washboard textures) from the mill planers, use a random orbital sander.
To avoid "
chatter marks" on inside corners and door trim, grip the sander firmly and move it up and down without touching the adjacent walls and trim.
This is important because an out-of-truth wheel can produce objectionable
chatter marks on the workpiece.
Its specially-engineered PVC formulation minimizes chipout and
chatter marks.
Sand with 100-grit sandpaper to remove the "
chatter marks," slight ridges that run across the face of the molding.
Chatter Marks. Believe it or not, most are caused by existing
chatter marks or rough edges.
"Knife or
chatter marks put in by the moulder are then expected to be cleaned up with the sanding.